How To Add A Hydraulic Pump To A Tractor
Learn how to add an auxiliary hydraulic pump to your tractor. Covers pump selection, installation steps, and t…
Olive Branch Hydraulics manufactures hydraulic gear pumps in Hebei, China. Send your tractor model, original part number and pump photographs when enquiring about this configuration.
The photograph shows an Italian-made reference unit for identification. The Chinese-made pump configuration must be checked against the shaft, mounting flange, oil ports and rotation of your original pump.
Catalogue search references include 5179724, 5130133 and C18X. Confirm the actual pump interfaces before ordering.
You need to confirm four interfaces on the pump in service before you send an RFQ.
Record the shaft type, which can be tapered with a key, splined or parallel keyed. Then record the main dimensions. For a spline, count the teeth and measure the major diameter. For a taper, give the taper ratio, the key width and the thread at the shaft end. Shaft length from the flange face counts as well, because the drive coupling in the tractor housing sets how far the shaft must engage.
Note the bolt pattern (2-bolt or 4-bolt), the bolt centre distance, the pilot diameter and the pilot depth. European agricultural pumps often use flange patterns that are close in size but do not interchange. Measure them with calipers. Do not judge them by eye.
Record whether the ports sit on the side or the rear, and whether they are threaded or flanged. Note the thread standard (metric, BSP or SAE) and the hole spacing on flanged ports. The inlet port is usually larger than the outlet port. Note which side faces the tank line on the tractor.
Gear pumps are typically single-direction units. Look at the pump from the shaft end and record whether the shaft turns clockwise or counter-clockwise. If the rotation is wrong, the pump will not prime, and the shaft seal can fail under inlet pressure. Many pumps carry an arrow or a letter code for rotation, so photograph the body markings as well.
A matching reference number together with an unconfirmed rotation or flange is the most common cause of a pump that does not fit.
We manufacture gear pumps and support OEM/ODM enquiries, tooling and private-label projects. Send your drawings or original sample, quantity and packaging requirements for assessment.
Include photographs and dimensions of the shaft, mounting flange and oil ports so the requested configuration can be reviewed.
Send the reference number, tractor model, rotation direction and quantity.
Pompa idraulica trattore Fiat; bomba hidráulica tractor Fiat; насос шестерённый Fiat; مضخة تروس جرار فيات; Fiat traktör hidrolik dişli pompası.
5179724, 5130133 and 568162 are reference numbers listed with the C18X steering pump. Merbok lists its HP-644 version at 8 cm³/rev. A separate catalogue for the CNH original lists 8.2 cm³/rev. Confirm the required displacement and interfaces against the original pump before ordering.
Catalogue applications include selected Fiat 580, 600, 640, 650, 680 and 780 tractors. Check the tractor serial number and steering circuit for the exact fit.
The gallery includes supplier reference photos and front and side dimensions for the right-hand 8.2 cm³/rev C18X version. Verify shaft, flange and ports on the original pump before ordering.
Learn how to add an auxiliary hydraulic pump to your tractor. Covers pump selection, installation steps, and t…
Skip priming and your gear pump dies in seconds. Learn the 5-minute procedure that prevents scoring, cavitatio…
Discover how hydraulic gear pumps work, why they still dominate industry, and key components to watch when spe…
Compare the most trusted hydraulic gear pump brands with a data-driven ranking built for procurement teams who…
Contact us now for a professional solution and fast quote.
Fill in your info to start a conversation.